Industrial aluminum cabinet production is very little use, if anyone USES the multicomponent, hybrid cleaner, because by the strong acid, alkali, carbonate, and secret recipe of stain remover, due to a single set of detergent with bad, so the appearance table is moderately live agent collaboration and suit cleaner, can have to wash the characteristics of implied respectively, thus can touch the development of clean power output.

Especially after the promotion of a few surface active agent can double the development of washing output power, the secret recipe of aluminum alloy profile cleaner can be in accordance with the cleaning oil stains, aluminum workpiece raw materials, cleaning methods, so after experimental judgment.

The application of industrial aluminum gusher cleaning method is common. Due to the disorder of machinery and equipment, the technical requirements are higher. For the good pretreatment effect, industrial aluminum manufacturers feel the need to strengthen care from the following areas:

1. Common demulsification methods include: inserting silicone defoamer; The use of low foam surface activator; Operating temperature; Reduce gas infiltration and so on. Foam and manipulation, in clean metal materials, the production of plastic foam or clear the former freedom of technology is very important, must have foam for some of the total freedom of technology is good, but the quality of industrial aluminum cleaner is not that the amount of foam plastics, and in the Wells, the requirement is low foam detergent, otherwise, mass production can't normal.

2. Prevent aluminum surface treatment from blocking in the facility to prevent corrosion. Strengthen technology benefits, strictly abide by the safety operation rules, check the management status every day, and investigate the main technical parameters at intervals.

3. As far as possible to reduce the cleaning solution hidden in the workpiece environmental pollution of the next process. In addition, multi-level water cleaning should be taken into account. Basically, two-level water cleaning is used, and some technologies are still washed with pure water. After the level of water cleaning tap water pollution is not more than one tenth of the previous level of cleaning parts, so that the residual liquid concentration value of two level of cleaning parts is only one percent of the original concentration value. When lifting cold water washing, backflow filling is used to save water resources.

Pay attention to the water cleaning quality, the workpiece in the whole process of degreasing technology, the surface contains residual liquid, if not cleaned, harm the quality of the material. Therefore, the residual liquid must be cleaned and removed from the surface of the workpiece called water cleaning.

In industrial production, in order to better save water resources, water cleaning tap water but generally recycled application, so water cleaning may gradually be contaminated by detergent.

The aluminum profile manufacturer introduces the daily washing and protecting methods